Please read the installation method and precautions in detail before using.
I.Features of Product:
-
The Heated thermal pad is integrated with the glass fiber reinforced plastic steel, impact resistant and can be washed by water or disinfected.
-
With low power consumption (120W) and high heat-conducting efficiency. The temperature on the surface can be 14℃ higher than the ambient temperature to make the abdomen in contact with the warm pad so as to increase the digestion and movement of saliva, gastric acid and bowel .
-
The power cable is anti-bite and anti-tear with a safe design.
-
The heating panel is configured with a leak resistant switch protector of high sensitivity on each piece to provide multiple securities.
-
It is favorable to pets to walk on the rough surface on the heating panel.
-
The actual results of the heating panel used: keep warm indoors and outdoors for reptile house in a zoo, National Pingtung University of Technology and Science and Council of Agricultural Wildlife Refuge Center.
II.Use and installation methods:
-
Select the appropriate specification and position. The product must be located at the flat bottom to prevent the product from being damaged by gravels and other things.
-
Pull the power wire out of the warm pad upward and fix it to avoid drooping (preferably set a rigid PVC tube into it).
-
Confirm the correct voltage supply before using. (It may burn by misusing 220v instead of 110v.)
-
View and touch the temperature on the surface about an hour after the power is supplied.
-
Method of the leak resistant switch and thermostat: Connect the power plug of the thermal pad to the thermostat and then to the leak resistant switch. After that, connect it to the 110v power supply.
* A wrong order will cause the leak resistant switch damaged without any warranty.
III.Precautions:
-
Do not pull the power cable when remove the thermal pad.
-
Do not drill or scrub the product with any sharp or hard object.
-
The surface must not be covered with poly-heat or low boiling point articles such as sacks, cloth, paper, etc.)
* With the high thermal efficiency, this product may cause the local overheat at the covered area, resulting in the aging, deformation or auto cut off.
-
The power supply must be installed with a leak resistant switch (The leak current is below 30MA) in order to ensure the safety of the human being and livestock.
* Refer to the facilities of the Electrical Code No. 62-1-2” for security.
-
Do not clean the thermal pad by the corrosive chemicals.
Warning:The incorrect use will cause the danger.